Time wage type selection rules---Generation of time wage types without T.E

We all know that Time Evaluation (T.E) is a program which generates overtime hours, absence or attendance quota and check working time provisions of employees. These overtime hours would then be valuated in Payroll. But here, my intention is to show how overtime hours maintained in Overtime infotype (2005) are picked up and valuated by the system when the Time Management Status is zero or 7 (Time evaluation without payroll integration), based on the conditions specified in T510S table (Time wage type selection table)

The configuration steps are as follows:

Copy TMOD PCR and customize it to set MODIF W to a value as per custom requirement based on organizational assignment . For example, here TMOD was copied into RTOD and MODIF W set to 56 (here) based on payroll area of the employees. Here, 56 is assigned to 3 ESG for PCR .i.e., to salaried employees as follows in the screenshot:

2.Similarly create a custom subschema of TC00( here RC00) and insert RTOD into it. Then create custom subschema of XT00( here MRT0) and insert RC00 into it. Finally, insert custom subschema MRT0 into custom International Payroll Schema (MR00).

3.The relevant wage types to be generated must be created and assigned valuation bases in V_512W_B---this is a pre-requisite. Here 3341 to 3348 eage types are created and assigned valuation basis as follows: 3341,3342, 3343 and 3344 are overtime wage types while 3345, 3346, 3347 and 3348 are bonus wage types

4.Define Generation rules based on time wage type selection rule group value (56) and Day grouping (Standard) as key parameters, specifying the various conditions a time pair must fulfill to generate the relevant wage type.